#[WNDR3700v3 dd-wrt.v24-27506_NEWD-2_K3.x_mega-nv64k.bin] Repeater Bridge working very well -

Linux version 3.10.83 (root@dd-wrt) (gcc version 5.1.0 (OpenWrt GCC 5.1.0 r45933) ) #8927 Thu Jul 9 08:05:39 CEST 2015
CPU revision is: 00019740 (MIPS 74Kc)
Found an ST compatible serial flash with 128 64KB blocks; total size 8MB
found nvram at 7F0000
something wrong here. do not remap
Determined physical RAM map:
 memory: 04000000 @ 00000000 (usable)
Zone ranges:
  Normal   [mem 0x00000000-0x03ffffff]
  HighMem  empty
Movable zone start for each node
Early memory node ranges
  node   0: [mem 0x00000000-0x03ffffff]
On node 0 totalpages: 16384
free_area_init_node: node 0, pgdat 805b7bf0, node_mem_map 81000000
  Normal zone: 128 pages used for memmap
  Normal zone: 0 pages reserved
  Normal zone: 16384 pages, LIFO batch:3
Primary instruction cache 32kB, 4-way, VIPT, I-cache aliases, linesize 32 bytes.
Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
pcpu-alloc: s0 r0 d32768 u32768 alloc=1*32768
pcpu-alloc: [0] 0 
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 16256
Kernel command line: console=ttyS0,115200 root=1f02 rootfstype=squashfs noinitrd init=/bin/sh
PID hash table entries: 256 (order: -2, 1024 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Writing ErrCtl register=00000000
Readback ErrCtl register=00000000
Memory: 57848k/65536k available (4654k kernel code, 7688k reserved, 1607k data, 324k init, 0k highmem)
NR_IRQS:128
CPU: BCM4716 rev 1 at 480 MHz
bcm947xx_clockevent_set_mode: 1
bcm947xx_clockevent_set_mode: 3
console [ttyS0] enabled
Calibrating delay loop... 239.61 BogoMIPS (lpj=1198080)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
NET: Registered protocol family 16
bio: create slab  at 0
PCI: Using membase 8000000
PCI: Initializing host
PCI: Reset RC
PCI: no core
PCI: scanning bus 0
PCI host bridge to bus 0000:00
pci_bus 0000:00: root bus resource [io  0x0000-0xffff]
pci_bus 0000:00: root bus resource [mem 0x00000000-0xffffffff]
pci_bus 0000:00: root bus resource [bus 00-ff]
pci 0000:00:00.0: [14e4:0800] type 00 class 0x050100
pci 0000:00:00.0: reg 10: [mem 0x18000000-0x18000fff]
pci 0000:00:00.0: reg 30: [mem 0x00000000-0x000007ff pref]
pci 0000:00:01.0: [14e4:4329] type 00 class 0x028000
pci 0000:00:01.0: reg 10: [mem 0x18001000-0x18001fff]
pci 0000:00:01.0: reg 30: [mem 0x00000000-0x000007ff pref]
pci 0000:00:02.0: [14e4:4715] type 00 class 0x020000
pci 0000:00:02.0: reg 10: [mem 0x18002000-0x18002fff]
pci 0000:00:02.0: reg 30: [mem 0x00000000-0x000007ff pref]
pci 0000:00:04.0: [14e4:471a] type 00 class 0x0c0310
pci 0000:00:04.0: reg 10: [mem 0x18009000-0x18009fff]
pci 0000:00:04.0: reg 30: [mem 0x00000000-0x000007ff pref]
pci 0000:00:04.1: [14e4:471a] type 00 class 0x0c0320
pci 0000:00:04.1: reg 10: [mem 0x18004000-0x18004fff]
pci 0000:00:04.1: reg 30: [mem 0x00000000-0x000007ff pref]
pci 0000:00:05.0: [14e4:0820] type 01 class 0x060400
pci 0000:00:05.0: reg 10: [mem 0x18005000-0x18005fff]
pci 0000:00:05.0: reg 38: [mem 0x00000000-0x000007ff pref]
pci 0000:00:06.0: [14e4:082e] type 00 class 0x050000
pci 0000:00:06.0: reg 10: [mem 0x18006000-0x18006fff]
pci 0000:00:06.0: reg 30: [mem 0x00000000-0x000007ff pref]
pci 0000:00:07.0: [14e4:080e] type 00 class 0x050000
pci 0000:00:07.0: reg 10: [mem 0x18007000-0x18007fff]
pci 0000:00:07.0: reg 30: [mem 0x00000000-0x000007ff pref]
pci 0000:00:08.0: [14e4:4711] type 00 class 0x040100
pci 0000:00:08.0: reg 10: [mem 0x18008000-0x18008fff]
pci 0000:00:08.0: reg 30: [mem 0x00000000-0x000007ff pref]
PCI: Fixing up bus 0
pci 0000:00:05.0: bridge configuration invalid ([bus 00-00]), reconfiguring
PCI/PCIe coreunit 0 is set to bus 1.
pci 0000:01:00.0: [14e4:4716] type 00 class 0x060000
pci 0000:01:00.0: reg 10: [mem 0x00000000-0x00003fff 64bit]
pci 0000:01:00.0: reg 18: [mem 0x00000000-0x07ffffff 64bit]
PCI: Fixing up bridge
cmd 6 new_cmd 6
pci 0000:01:00.0: supports D1 D2
pci 0000:01:00.1: [14e4:0000] type 00 class 0x060000
pci 0000:01:00.1: reg 10: [mem 0x00000000-0x00003fff 64bit]
pci 0000:01:00.1: reg 18: [mem 0x00000000-0x07ffffff 64bit]
PCI: Fixing up bridge
cmd 6 new_cmd 4
PCI: Enabling device 0000:01:00.1 (0004 -> 0006)
pci 0000:01:00.1: supports D1 D2
pci 0000:01:01.0: [14e4:4331] type 00 class 0x028000
pci 0000:01:01.0: reg 10: [mem 0x00000000-0x00003fff 64bit]
pci 0000:01:01.0: supports D1 D2
PCI: Fixing up bus 1
pci_bus 0000:01: busn_res: [bus 01-ff] end is updated to 01
Switching to clocksource MIPS
NET: Registered protocol family 2
TCP established hash table entries: 512 (order: 0, 4096 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 512 bind 512)
TCP: reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
PCI: CLS 0 bytes, default 32
WNDR4000 GPIO Init
squashfs: version 3.0 (2006/03/15) Phillip Lougher
msgmni has been set to 112
io scheduler noop registered (default)
HDLC line discipline maxframe=4096
N_HDLC line discipline registered.
Serial: 8250/16550 driver, 4 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x0 (irq = 8) is a U6_16550A
brd: module loaded
pflash: found no supported devices
try to find cfe size up to 8388608
bootloader size: 262144
nvram size: 65536
bcmsflash: Filesystem type: squashfs, size=0x5a646c
partition size = 2353151
Updating TRX offsets and length:
old trx = [0x0000001c, 0x00000930, 0x001ee800], len=0x00796000 crc32=0x15df4e45
new trx = [0x0000001c, 0x00000930, 0x001ee800], len=0x007a0000 crc32=0xaa4cea84
Done
Creating 4 MTD partitions on 0930, bcmsflash0], le:
0x000000000000-0x000000040000 : 0, bcmcfeot;0],
0x000000040000-0x0000007e0000 : 0, bcmlinux;0],
0x00000022e800-0x0000007e0000 : 0, bcmrootfs0],
mtd: partition 0x0000rootfs00 : 0 must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only
mtd: partition 0x0000rootfs00 : 0 set to be root filesystem
0x0000007f0000-0x000000800000 : 0 set nvram;root 
brcmnand: found no supported devices
nflash: found no supported devices
tun: Universal TUN/TAP device driver, 1.6
tun: (C) 1999-2004 Max Krasnyansky 
et_module_init: passivemode set to 0x0
et_module_init: txworkq set to 0x0
et_module_init: et_txq_thresh set to 0x400
et_module_init: et_rxlazy_timeout set to 0x3e8
et_module_init: et_rxlazy_framecnt set to 0x20
et 0000:00:02.0: setting latency timer to 64
eth0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 7.14.89.21 (r524987)
PPP generic driver version 2.4.2
PPP BSD Compression module registered
PPP Deflate Compression module registered
PPP MPPE Compression module registered
NET: Registered protocol family 24
wl 0000:00:01.0: setting latency timer to 64
cmd 2 new_cmd 0
PCI: Enabling device 0000:01:01.0 (0000 -> 0002)
Broadcom Watchdog Timer: 0.07 initialized.
u32 classifier
    Performance counters on
    Actions configured
Netfilter messages via NETLINK v0.30.
nf_conntrack version 0.5.0 (903 buckets, 3612 max)
nf_conntrack_rtsp v0.6.21 loading
xt_time: kernel timezone is -0000
ip_set: protocol 6
gre: GRE over IPv4 demultiplexor driver
nf_nat_rtsp v0.6.21 loading
ip_tables: (C) 2000-2006 Netfilter Core Team
TCP: bic registered
TCP: cubic registered
TCP: westwood registered
TCP: highspeed registered
TCP: hybla registered
TCP: htcp registered
TCP: vegas registered
TCP: veno registered
TCP: scalable registered
TCP: lp registered
TCP: yeah registered
TCP: illinois registered
NET: Registered protocol family 17
Bridge firewalling registered
8021q: 802.1Q VLAN Support v1.8
startup nvram driver
found nvram
VFS: Mounted root (squashfs filesystem) readonly on device 31:2.
Freeing unused kernel memory: 324K (8061f000 - 80670000)
roboswitch: Probing device 'eth0'
roboswitch: trying a 53115! at eth0
roboswitch: found a 53115! at eth0
emf: module license 'Proprietary' taints kernel.
Disabling lock debugging due to kernel taint
device br0 entered promiscuous mode
device vlan1 entered promiscuous mode
device eth0 entered promiscuous mode
device eth1 entered promiscuous mode
device wl0.1 entered promiscuous mode
device eth2 entered promiscuous mode
device vlan2 entered promiscuous mode
br0: port 5(vlan2) entered forwarding state
br0: port 5(vlan2) entered forwarding state
br0: port 4(eth2) entered forwarding state
br0: port 4(eth2) entered forwarding state
br0: port 3(wl0.1) entered forwarding state
br0: port 3(wl0.1) entered forwarding state
br0: port 2(eth1) entered forwarding state
br0: port 2(eth1) entered forwarding state
br0: port 1(vlan1) entered forwarding state
br0: port 1(vlan1) entered forwarding state
device br0 left promiscuous mode
device br0 entered promiscuous mode
device br0 left promiscuous mode
br0: port 5(vlan2) entered forwarding state
br0: port 4(eth2) entered forwarding state
br0: port 3(wl0.1) entered forwarding state
br0: port 2(eth1) entered forwarding state
br0: port 1(vlan1) entered forwarding state