#[WNDR3700v3 dd-wrt.v24-27506_NEWD-2_K2.6_mega-nv64k.bin] Repeater Bridge NOT working - Linux version 2.6.24.111 (root@dd-wrt) (gcc version 4.1.2) #26260 Thu Jul 9 00:38:23 CEST 2015 CPU revision is: 00019740 Found a 8MB ST compatible serial flash Determined physical RAM map: memory: 04000000 @ 00000000 (usable) Entering add_active_range(0, 0, 16384) 0 entries of 256 used Zone PFN ranges: Normal 0 -> 16384 HighMem 16384 -> 16384 Movable zone start PFN for each node early_node_map[1] active PFN ranges 0: 0 -> 16384 On node 0 totalpages: 16384 Normal zone: 0 pages used for memmap Normal zone: 0 pages reserved Normal zone: 16384 pages, LIFO batch:3 HighMem zone: 0 pages used for memmap Movable zone: 0 pages used for memmap Built 1 zonelists in Zone order. Total pages: 16384 Kernel command line: console=ttyS0,115200 root=1f02 rootfstype=squashfs noinitrd Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes. Primary data cache 32kB, 4-way, linesize 32 bytes. Synthesized TLB refill handler (20 instructions). Synthesized TLB load handler fastpath (32 instructions). Synthesized TLB store handler fastpath (32 instructions). Synthesized TLB modify handler fastpath (31 instructions). PID hash table entries: 512 (order: 9, 2048 bytes) CPU: BCM4716 rev 1 at 480 MHz Using 240.000 MHz high precision timer. console [ttyS0] enabled Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) Memory: 58628k/65536k available (3490k kernel code, 6852k reserved, 1369k data, 220k init, 0k highmem) Calibrating delay loop... 239.20 BogoMIPS (lpj=1196032) Mount-cache hash table entries: 512 NET: Registered protocol family 16 Generic PHY: Registered new driver PCI: Using membase 8000000 PCI: Initializing host PCI: Reset RC PCI: no core PCI: Fixing up bus 0 PCI/PCIe coreunit 0 is set to bus 1. PCI: Fixing up bridge PCI: Setting latency timer of device 0000:01:00.0 to 64 PCI: Fixing up bridge PCI: Setting latency timer of device 0000:01:00.1 to 64 PCI: Enabling device 0000:01:00.1 (0004 -> 0006) PCI: Fixing up bus 1 NET: Registered protocol family 2 Time: MIPS clocksource has been installed. IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 2048 (order: 2, 16384 bytes) TCP bind hash table entries: 2048 (order: 1, 8192 bytes) TCP: Hash tables configured (established 2048 bind 2048) TCP reno registered WNDR4000 GPIO Init devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x1 squashfs: version 3.0 (2006/03/15) Phillip Lougher io scheduler noop registered io scheduler deadline registered (default) HDLC line discipline: version $Revision: 4.8 $, maxframe=4096 N_HDLC line discipline registered. Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled serial8250: ttyS0 at MMIO 0x0 (irq = 8) is a 16550A PPP generic driver version 2.4.2 PPP Deflate Compression module registered PPP BSD Compression module registered MPPE/MPPC encryption/compression module registered NET: Registered protocol family 24 tun: Universal TUN/TAP device driver, 1.6 tun: (C) 1999-2004 Max Krasnyansky et_module_init: passivemode set to 0x0 PCI: Setting latency timer of device 0000:00:02.0 to 64 VID 0 is set in nvram, Ignoring eth0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.100.138.9 PCI: Setting latency timer of device 0000:00:01.0 to 64 PCI: Enabling device 0000:01:01.0 (0000 -> 0002) PCI: Setting latency timer of device 0000:01:01.0 to 64 pflash: found no supported devices bootloader size: 262144 nvram size: 65536 sflash: Filesystem type: squashfs, size=0x60cdd4 partition size = 6366208 Updating TRX offsets and length: old trx = [0x0000001c, 0x000009d0, 0x0015dc00], len=0x0076b000 crc32=0xaa209d95 new trx = [0x0000001c, 0x000009d0, 0x0015dc00], len=0x00770000 crc32=0xea94aa57 Done Creating 6 MTD partitions on "sflash": 0x00000000-0x00040000 : "cfe" 0x00040000-0x007e0000 : "linux" 0x0019dc00-0x007b0000 : "rootfs" mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only 0x007f0000-0x00800000 : "nvram" 0x007b0000-0x007e0000 : "ddwrt" 0x007e0000-0x007f0000 : "board_data" Broadcom Watchdog Timer: 0.07 initialized. u32 classifier Performance counters on Actions configured Netfilter messages via NETLINK v0.30. nf_conntrack version 0.5.0 (1024 buckets, 4096 max) ctnetlink v0.93: registering with nfnetlink. IPv4 over IPv4 tunneling driver GRE over IPv4 tunneling driver ip_tables: (C) 2000-2006 Netfilter Core Team ClusterIP Version 0.8 loaded successfully TCP bic registered TCP cubic registered TCP westwood registered TCP highspeed registered TCP hybla registered TCP htcp registered TCP vegas registered TCP scalable registered NET: Registered protocol family 1 NET: Registered protocol family 17 Welcome to PF_RING 3.2.1 (C) 2004-06 L.Deri NET: Registered protocol family 27 PF_RING: bucket length 128 bytes PF_RING: ring slots 4096 PF_RING: sample rate 1 [1=no sampling] PF_RING: capture TX No [RX only] PF_RING: transparent mode Yes PF_RING initialized correctly. PF_RING: registered /proc/net/pf_ring/ 802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Miller decode 1f02 VFS: Mounted root (squashfs filesystem) readonly. Mounted devfs on /dev Freeing unused kernel memory: 220k freed roboswitch: Probing device eth0: found a 53115! br0: Dropping NETIF_F_UFO since no NETIF_F_HW_CSUM feature. device br0 entered promiscuous mode device vlan1 entered promiscuous mode device eth0 entered promiscuous mode device eth1 entered promiscuous mode device wl0.1 entered promiscuous mode device eth2 entered promiscuous mode device vlan2 entered promiscuous mode br0: port 5(vlan2) entering learning state br0: port 4(eth2) entering learning state br0: port 3(wl0.1) entering learning state br0: port 2(eth1) entering learning state br0: port 1(vlan1) entering learning state device br0 left promiscuous mode device br0 entered promiscuous mode device br0 left promiscuous mode nf_conntrack_h323: Unknown symbol ip6_route_output nf_nat_h323: Unknown symbol nat_callforwarding_hook nf_nat_h323: Unknown symbol nat_t120_hook nf_nat_h323: Unknown symbol set_h225_addr_hook nf_nat_h323: Unknown symbol set_ras_addr_hook nf_nat_h323: Unknown symbol nat_q931_hook nf_nat_h323: Unknown symbol nat_rtp_rtcp_hook nf_nat_h323: Unknown symbol set_sig_addr_hook nf_nat_h323: Unknown symbol get_h225_addr nf_nat_h323: Unknown symbol nat_h245_hook nf_nat_h323: Unknown symbol set_h245_addr_hook br0: topology change detected, propagating br0: port 5(vlan2) entering forwarding state br0: topology change detected, propagating br0: port 4(eth2) entering forwarding state br0: topology change detected, propagating br0: port 3(wl0.1) entering forwarding state br0: topology change detected, propagating br0: port 2(eth1) entering forwarding state br0: topology change detected, propagating br0: port 1(vlan1) entering forwarding state root@3700v3-RptBrdg:~# exit Connection closed by foreign host.